Agilent 1100 Fraction Collector (G1364C)

Manufacturer: Agilent Technologies
Model: G1364C Condition: Refurbished


  • 1100 Fraction Collector (G1364C)
  • Full tray for 126 test tubes (16mm OD, max height 48mm)
  • CAN Cable
  • One (1) Year In-House Repair Warranty


  • Extended Warranty

More details

Item#: 11261

Protection & Services

Repair Service
Instrument not working properly?
Get a Free Quote Estimate Today
Repair Service
Not exactly what you are looking for?
Build your own custom system

Agilent 1100 Fraction Collector (G1364C)


Operating Modes: 

  • Discrete fractions: default mode for all vessels. The flow is diverted to waste, while moving from one vessel position to the next vessel position
  • Continuous flow: optional, available only when using the deep well plates. It is possible to move from one well plate position to the next one without diverting the flow into the well plate to waste Needle into location: Needle pushes into the vessel as deep as specified, for the use with capped vials and test tubes and well plates with closing mats
  • Droplet setup mode: The tip of the fraction collector needle will initially move down to the bottom of the well. Then it will slowly move upwards while the fraction is collected. The droplet setup mode enables the fraction collector to collect small fractions without bubbles.

Trigger Modes:  Time slices, Peak (threshold, up- / downslope), Timetable (combination of time intervals and peak) and Manual trigger

Fraction Trays:  Installed trays are automatically detected and identified. Installed plates and vials can be detected when operating in the needle into location mode.

Safety Features:   Leak detection and safe leak handling, error detection and display, exhaust fan for fume extraction of hazardous vapors


Maximum tube / Plate height:48 mm with long needle assembly. 75 mm with short needle assembly
Maximum tube volume: ca. 20 ml with 48 mm test tubes, ca. 30 ml with 75 mm test tubes or unlimited, if funnels are used with external containers.
Maximum flow rate: 10 ml / min (depending on viscosity and generated back pressure, max. 6 bar at the diverter valve). The analytical scale fraction collector can be modified for flow rates > 10 ml/min
Delay Volumes [µl]:Fraction collector inlet to diverter valve: ~50 (typical, depends on the length of the tubing)
Diverter valve: ~15
Diverter valve to needle: ~10
Needle: ~4
Delay Calibration Sensor:Single wavelength absorbance detector working at 654 nm, consisting of a LED and a photo diode
Diverter Valve:3/2 Diverter valve with low internal volume (15 µl), switching time < 100 ms, maximum operating pressure 6 bar
Cooling:Optional (with additional G1330B), performance depending on ambient conditions and the volume of collected fractions
Maximum Capacity: 3 fraction collectors in parallel plus one recovery fraction collector connected via 12-Position, 13-Port Selector valve

The GenTech Difference

Why Buy New When You Don't Have To? Our refurbished Agilent HPLC Module have been expertly restored to meet OEM standards. GenTech is a full service reseller, our knowledgeable engineers perform installations, repairs, training and method development. The inventory in our 60,000 sq. foot facility is constantly changing with new shipments coming in daily. GenTech customers receive lifetime phone support for all instruments they purchase.

How we refurbish used analytical instruments

Every refurbished instrument we sell under goes a complete inspection of all electronics and performance review. The instruments undergo in-depth preventative maintenance procedures that include extensive cleaning, detector maintenance, line and pump flushing. Routine maintenance is also addressed and filters, liners, tubing, etc. are all replaced as needed. Our chemist perform full calibration and data verification. Once used Agilent HPLC Module are returned to like-new condition and will run your samples for 30-80% off retail.

This refurbished Agilent 1100 Fraction Collector (G1364C) is calibrated to meet OEM standards. Our expert service engineers and chemists can install and custom configure the system to be compliant with the Methods you plan to run.

Get cash or purchase credit for your unwanted laboratory assets!

GenTech buys a wide range of equipment from Agilent, Thermo, Waters, AB Sciex, Shimadzu, Perkin Elmer, and More! Since 1996 GenTech Scientific has purchased used laboratory equipment to refurbish and resell with 1 Year warranties. Our refurbished equipment comes fully tested, and supported long after the manufacturers! If you have old or unused lab equipment in your laboratory that you are looking to sell, contact GenTech and see how we can help you!

Trade-In for Purchase Credit

Apply your trade-in value towards your next purchase! Learn more about Trade-In's.

If you have a trade-in complete the quote request form including the instruments you wish to purchase and the equipment you have to trade. Click here to Request a Quote.

Sell Your Lab Equipment

GenTech is currently interested in purchasing GC, HPLC, MS, LC/MS, ICP/MS equipment and laboratory accessories! Click Here to see a complete list.

To sell your equipment please include the make, model and pictures of the instruments you have to sell. Click here to Contact the Purchasing Department.

flags Acerca de GenTech - Ver Mas